Subaru LEGACY 2006 Manual page 393

asieps_tobira.book 31 ページ ２００９年１０月２６日 月曜日 午前９時１６分
7. LED OPERATION MODE FOR ENGINE
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}, and then press the
[YES] key.
5) On the «Data Display» screen, select the {Data LED Display} and press the [YES] key.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
A list of the support data is shown in the following table.
Remarks
AT/MT identification signal
Test mode signal
Neutral position switch signal
Idle switch signal
Ignition switch signal
Power steering switch signal
Air conditioning switch signal
Starter switch signal
Rear oxygen sensor rich signal
Knocking signal
Crankshaft position sensor signal
Camshaft position sensor signal
Rear defogger switch signal
Blower fan switch signal
Light switch signal
A/C middle pressure switch signal
Air conditioning relay signal
Radiator fan relay 1 signal
Radiator fan relay 2 signal
Fuel pump relay signal
PCV hose assembly diagnosis signal
Pressure control solenoid valve signal PCV Solenoid Valve
Drain valve signal
Variable valve lift diagnosis oil pres-
sure switch signal 1
Variable valve lift diagnosis oil pres-
sure switch signal 2
Subaru Select Monitor
Display
AT Vehicle ID Signal ON or OFF
Test Mode Terminal U check or D check
Neutral Position Switch ON or OFF
Idle Switch Signal ON or OFF
Ignition Switch ON or OFF
P/S Switch ON or OFF
A/C Switch ON or OFF
Starter Switch ON or OFF
Rear O2 Rich Signal Rich or Lean
Knocking Signal Provided or None
Crankshaft Position Signal Provided or None
Camshaft Position Signal Provided or None
Rear Defogger Switch ON or OFF
Blower Fan Switch ON or OFF
Light Switch ON or OFF
A/C Mid Pressure Switch ON or OFF
A/C Compressor Signal ON or OFF
Radiator Fan Relay #1 ON or OFF
Radiator Fan Relay #2 ON or OFF
Fuel Pump Relay ON output or OFF output
Connected or Not con-
Blow-by Leak Connector
nected
ON or OFF
Vent Control Solenoid ON or OFF
Oil Press. SW1 ON or OFF
Oil Press. SW2 ON or OFF
EN(H4SO)(diag)-31
ENGINE (DIAGNOSTICS)
Message LED "ON" requirements
Illuminate (AT model)
D check
When neutral position signal is
input.
When idle switch signal is
input.
When ignition switch is turned
ON.
When power steering switch is
entered.
When air conditioning switch is
input.
When starter switch is input.
When rear oxygen sensor mix-
ture ratio is rich.
When knocking signal is input.
When crankshaft position sen-
sor signal is input.
When camshaft position sensor
signal is input.
When rear defogger switch is
turned to ON.
When blower fan switch is
turned to ON.
When light switch is turned ON.
When A/C middle pressure
switch is turned to ON.
When air conditioning relay is
in function.
When radiator fan relay 1 is in
function.
When radiator fan relay 2 is in
function.
ON output
PVC hose assembly connected
Pressure control solenoid valve
is operated.
Drain valve is operated.
When variable valve lift diagno-
sis oil pressure switch signal 1
is ON.
When variable valve lift diagno-
sis oil pressure switch signal 2
is ON.