Subaru LEGACY 2006 Manual page 879

asieps_tobira.book 23 ページ ２００９年１０月２６日 月曜日 午前９時１６分
6) Using the bearing puller, remove the bearings
from the rotor.
7) Disconnect the connection between the rectifier
and stator coil, then remove the stator coil.
CAUTION:
The recitifer is easily damaged by heat. Do not
allow a 180 — 270 W soldering iron to contact
the terminals for more than 5 seconds at a time.
8) Use the following procedures to remove the IC
regulator.
(1) Remove the screws which secure the IC
regulator to the rear cover.
Generator
(2) Disconnect the connection between the IC
regulator and rectifier, then remove the IC reg-
ulator.
SC-00046
9) Use the following procedures to remove the
brush.
(1) Remove the cover A.
(A) Cover A
SC-00083
(2) Remove the cover B.
(A) Cover B
SC-00084
SC(H4SO)-23
STARTING/CHARGING SYSTEMS
SC-00085
(A)
SC-00086
(A)
SC-00087