Subaru LEGACY 2006 Manual page 838

asieps_tobira.book 64 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
29) Rotate the crankshaft to bring #1 and #2 pis-
tons to bottom dead center position, then remove
the piston snap ring through service hole of #1 and
#2 cylinders.
30) Draw out the piston pin from #1 and #2 pistons
using ST.
ST 499097700 PISTON PIN REMOVER
NOTE:
Be careful not to confuse the original combination
of piston, piston pin and cylinder.
31) Similarly remove the piston pins from #3 and #4
pistons.
32) Remove the bolts which connect cylinder block
on the side of #2 and #4 cylinders.
33) Back off the bolts which connect cylinder block
on the side of #1 and #3 cylinders two or three
turns.
34) Set up the cylinder block so that #1 and #3 cyl-
inders are on the upper side, then remove the cyl-
inder block connecting bolts.
Cylinder Block
ME-00141
ST
ME-00142
ME(H4SO)-64