Subaru LEGACY 2006 Manual page 754

asieps_tobira.book 3 ページ ２００９年１０月２６日 月曜日 午前９時１６分
(1) Air intake duct
(2) Clip
(3) Resonator chamber
(4) Air cleaner case (front)
(5) Spacer
(6) Cushion
(7) Air cleaner element
(8) Air cleaner case (rear)
(9) Clip
(10) Clamp
B: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
the battery.
General Description
(11) Intake duct
(12) Clamp
(13) Cushion
(14) Spacer
(15) Air intake chamber
(16) Stay LH (MT model)
(17) Stay LH (AT model)
(18) Clamp
(19) Stay RH
(20) Cushion
IN(H4SO)-3
INTAKE (INDUCTION)
(21) Mass air flow and intake air tem-
perature sensor
Tightening torque: N·m (kgf-m, ft-lb)
T1: 6.0 (0.6, 4.4)
T2: 6.5 (0.66, 4.8)
T3: 16 (1.6, 11.6)
T4: 3.0 (0.3, 2.2)
T5: 7.5 (0.76, 5.5)
T6: 1.0 (0.10, 0.7)