Subaru LEGACY 2006 Manual page 395

asieps_tobira.book 36 ページ ２００９年１０月２６日 月曜日 午前９時１６分
ENGINE (DIAGNOSTICS)
1. PREPARATION FOR THE INSPECTION
MODE
1) Check that the battery voltage is 12 V or more
and fuel remains approx. half [20 — 40 2 (5.3 —
10.6 US gal, 4.4 — 8.8 Imp gal)].
2) Lift-up the vehicle using a garage jack and place
it on rigid racks, or drive the vehicle onto free roll-
ers.
WARNING:
• Before lifting-up the vehicle, ensure parking
brakes are applied.
• Do not use a pantograph jack in place of a rig-
id rack.
• Secure a rope or wire to the front or rear tow-
ing hooks to prevent the lateral runout of front
wheels.
• Do not abruptly depress/release clutch pedal
or accelerator pedal during works even when
the engine is operating at low speeds since this
may cause vehicle to jump off free rollers.
• In order to prevent the vehicle from slipping
due to vibration, do not place any wooden
blocks or similar items between the rigid racks
and vehicle.
• Since the rear wheels will also rotate, do not
place anything near them. Also, make sure that
nobody goes in front of the vehicle.
(A) Rigid rack
(B) Free rollers
Inspection Mode
(A)
(B)
EN-00041
EN(H4SO)(diag)-36
2. SUBARU SELECT MONITOR
1) After clearing the memory, check for any remain-
ing unresolved trouble data. <Ref. to EN(H4SO)(di-
ag)-43, Clear Memory Mode.>
2) Warm-up the engine.
3) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4SO)(diag)-7, PREPARATION TOOL, Gen-
eral Description.>
4) Connect the diagnosis cable to Subaru Select
Monitor.
5) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H4SO)(diag)-7, PREPARATION TOOL,
General Description.>
6) Connect the test mode connector (A) located un-
der the glove box.
(A)
EN-00038
EN-00039
PI-00201