Subaru LEGACY 2006 Manual page 807

asieps_tobira.book 41 ページ ２００９年１０月２６日 月曜日 午前９時１６分
7) Remove the belt idler No. 2.
(A)
(A) Belt idler (No. 2)
(B) Belt idler No. 2
8) Remove the timing belt.
2. BELT IDLER AND AUTOMATIC BELT
TENSION ADJUSTER ASSEMBLY
1) Remove the belt idler (No. 1).
2) Remove the automatic belt tension adjuster as-
sembly.
Timing Belt
(B)
ME-02434
ME-02388
ME-00237
ME-00238
ME(H4SO)-41
B: INSTALLATION
1. AUTOMATIC BELT TENSION ADJUST-
ER ASSEMBLY AND BELT IDLER
1) Preparation for installation of automatic belt ten-
sion adjuster assembly.
CAUTION:
• Always use a vertical type pressing tool to
move the adjuster rod down.
• Do not use a lateral type vise.
• Push the adjuster rod vertically.
• Press-in the push adjuster rod gradually tak-
ing more than three minutes.
• Do not allow press pressure to exceed 9,807
N (1,000 kgf, 2,205 lb).
• Press the adjuster rod as far as the end sur-
face of the cylinder. Do not press the adjuster
rod into cylinder. Doing so may damage the cyl-
inder.
• Do not release the press pressure until stop-
per pin is completely inserted.
(1) Attach the automatic belt tension adjuster
assembly to vertical pressing tool.
(2) Slowly move the adjuster rod down with a
pressure of more than 165 N (16.8 kgf, 37.1 lb)
until the adjuster rod is aligned with the stopper
pin hole in the cylinder.
(3) With a 2 mm (0.08 in) dia. stopper pin or a 2
mm (nominal) dia. hex wrench inserted into the
stopper pin hole in cylinder, secure the adjuster
rod.
MECHANICAL
ME-00239
ME-00350