Subaru LEGACY 2006 Manual page 694

asieps_tobira.book 36 ページ ２００９年１０月２６日 月曜日 午前９時１６分
FUEL INJECTION (FUEL SYSTEMS)
17.Engine Control Module (ECM)
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the lower inner trim of passenger's
side.
<Ref. to EI-59, REMOVAL, Lower Inner Trim.>
3) Detach the floor mat of passenger's seat.
4) Remove the protect cover.
5) Remove the bolts and nuts which hold the ECM
to the bracket.
6) Remove the clip (A) from bracket.
(A)
7) Disconnect the ECM connectors, and take out
the ECM.
Engine Control Module (ECM)
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
• When replacing the ECM, be careful not to
use the ECM for wrong specifications to avoid
any damage to fuel injection system.
• When replacing the ECM, be careful not to
damage the harnesses and connectors.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
IN-00203
FU-02090
FU-02488
FU(H4SO)-36