Subaru LEGACY 2006 Manual page 283

asieps_tobira.book 246 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
7 CHECK INHIBITOR SWITCH GROUND LINE.
Measure the resistance of harness between
inhibitor switch connector and engine ground.
Connector & terminal
(T7) No. 12 — Engine ground:
8 CHECK INHIBITOR SWITCH.
Measure the resistance between inhibitor
switch connector receptacle's terminals with
select lever at "N" and "P" range.
Terminals
No. 7 — No. 12:
Check
Is the resistance less than 5 Ω? Go to step 8.
Is the resistance less than 1 Ω? Contact the SOA
EN(H4SO)(diag)-246
Yes No
Repair open circuit
of harness
between inhibitor
switch connector
and starter motor
ground line.
NOTE:
In this case, repair
the following item:
• Open circuit in
harness between
inhibitor switch
connector
starter motor
ground line
• Poor contact in
starter motor con-
nector
• Poor contact in
starter motor
ground
• Starter motor
Replace the inhibi-
service center. tor switch. <Ref. to
4AT-46, Inhibitor
Switch.>
and