Subaru LEGACY 2006 Manual page 731

asieps_tobira.book 50 ページ ２００９年１０月２６日 月曜日 午前９時１６分
FUEL INJECTION (FUEL SYSTEMS)
24.Fuel Pump
A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel.
NOTE:
Fuel pump assembly consists of fuel pump and fuel
level sensor.
1) Release the fuel pressure. <Ref. to FU(H4SO)-
40, RELEASING OF FUEL PRESSURE, PROCE-
DURE, Fuel.>
2) Drain fuel. <Ref. to FU(H4SO)-40, DRAINING
FUEL, PROCEDURE, Fuel.>
3) Remove the rear seat.
4) Remove the service hole cover.
5) Disconnect the connector from fuel pump.
6) Disconnect the quick connector, then disconnect
the fuel delivery hose and jet pump hose. <Ref. to
FU(H4SO)-56, REMOVAL, Fuel Delivery and
Evaporation Lines.>
Fuel Pump
7) Remove the nuts which install fuel pump assem-
bly onto fuel tank.
(A) Delivery hose
(B) Jet pump hose
8) Remove the fuel pump assembly from the fuel
tank.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• Use a new gasket.
• Make sure the sealing portion is free from fuel or
foreign matter before installation.
• When assembling, point the protrusion of the
gasket (A) towards the front of the vehicle.
FU-02387
• Insert the protrusion (B) of the gasket into the up-
per plate. (3 locations)
• Align the protrusion (C) of the fuel pump assem-
bly to the cut out in the upper plate.
• Tighten the nuts to the specified torque in the or-
der as shown in the figure.
Tightening torque:
4.4 N·m (0.45 kgf-m, 3.2 ft-lb)
FU-02669
FU(H4SO)-50
(B)
(A)
FU-02670
(C)
1
4
8
(B)
(B)
6 5
3
7
2
(A)
(B)
FU-02835