Subaru LEGACY 2006 Manual page 48

asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分
PRE-DELIVERY INSPECTION
19.CLUTCH FLUID
Check that the clutch fluid level is normal. If the
amount of fluid is insufficient, check that no leaks
are found. Then, add the necessary amount of
specified fluid.
(A)
(A) Reservoir tank
(B) MIN. level
(C) MAX. level
20.WINDOW WASHER FLUID
Check that the window washer fluid level is normal.
If the amount is insufficient, check that no leaks are
found. Then, add the necessary amount of washer
fluid.
21.FRONT HOOD LATCH CHECK
Retract the front hood stay and close the front
hood. Check that the front hood is securely latched.
Pre-delivery Inspection
22.KEYLESS ENTRY SYSTEM
NOTE:
The following inspections show the initial settings.
When the settings are different from the initial set-
tings, use Subaru Select Monitor to check the de-
tails of each setting for inspections. <Ref. to
LAN(diag)-27, OPERATION, Read Current Data.>
1) Fully open all the door windows.
2) Remove the key from the ignition switch and
close all the doors including rear gate.
(C)
3) Press the rear gate and trunk open button for
more than one second.
• Check if the trunk is opened and the hazard light
blinks twice and the buzzer sounds twice. (Sedan
(B) model)
PI-00253
• Check if the rear gate is unlocked and the hazard
light blinks twice and the buzzer sounds twice.
(Wagon model)
4) Press the "LOCK" button on the keyless trans-
mitter with one of the doors (including the rear gate
and trunk) opened. Check if all the doors are
locked, hazard light blinks five times and the buzzer
sounds five times and warning shows one of the
doors (including the rear gate and trunk) open.
5) Close all the doors including rear gate and trunk.
Press the "LOCK" button momentarily on the key-
less transmitter. Check that all the doors (including
rear gate and trunk) are locked, hazard light blinks
once and buzzer sounds once.
PI-10
PI-00254
PI-00255