Subaru LEGACY 2006 Manual page 848

asieps_tobira.book 74 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
31) Install the water pump and gasket.
Tightening torque:
First: 12 N·m (1.2 kgf-m, 8.7 ft-lb)
Second: 12 N·m (1.2 kgf-m, 8.7 ft-lb)
CAUTION:
• Be sure to use a new gasket.
• When installing the water pump, tighten bolts
in two stages in alphabetical sequence as
shown in the figure.
(C)
(D)
(E)
32) Install the water by-pass pipe for heater.
33) Install the oil filter.
<Ref. to LU(H4SO)-19, INSTALLATION, Engine
Oil Filter.>
34) Tighten the cylinder head bolts. <Ref. to
ME(H4SO)-54, INSTALLATION, Cylinder Head.>
35) Install the oil level gauge guide and tighten the
bolts. (LH side only)
36) Install the rocker cover and rocker cover gas-
ket.
NOTE:
Use a new rocker cover gasket.
37) Install the crank sprocket.
<Ref. to ME(H4SO)-46, INSTALLATION, Crank
Sprocket.>
38) Install the cam sprocket. <Ref. to ME(H4SO)-
45, INSTALLATION, Cam Sprocket.>
39) Install the timing belt. <Ref. to ME(H4SO)-41,
INSTALLATION, Timing Belt.>
40) Install the timing belt cover.
<Ref. to ME(H4SO)-39, INSTALLATION, Timing
Belt Cover.>
41) Install the crank pulley. <Ref. to ME(H4SO)-38,
INSTALLATION, Crank Pulley.>
42) Install the generator and A/C compressor
brackets on cylinder head.
43) Install the V-belts. <Ref. to ME(H4SO)-36, IN-
STALLATION, V-belt.>
44) Install the intake manifold.
<Ref. to FU(H4SO)-13, INSTALLATION, Intake
Manifold.>
Cylinder Block
(B)
(A)
(F)
ME-02463
ME(H4SO)-74