Subaru LEGACY 2006 Manual page 772

asieps_tobira.book 36 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MECHANICAL
12.V-belt
A: REMOVAL
NOTE:
Perform the following procedures with the engine
installed to body.
1. FRONT SIDE BELT
1) Remove the V-belt covers.
2) Loosen the lock bolt (A).
3) Loosen the slider bolt (B).
4) Remove the front side belt (C).
(B)
(C)
(A)
2. REAR SIDE BELT
1) Loosen the lock nut (A).
2) Loosen the slider bolt (B).
(B)
3) Remove the rear side belt.
V-belt
4) Remove the belt tensioner.
B: INSTALLATION
NOTE:
Wipe off any oil and water on the belt and pulley.
1. FRONT SIDE BELT
1) Install the V belt, and tighten the slider bolt to ob-
tain the specified belt tension. <Ref. to ME(H4SO)-
ME-00222
37, INSPECTION, V-belt.>
2) Tighten the lock bolt (A).
3) Tighten the slider bolt (B).
Tightening torque:
Lock bolt (A)
25 N·m (2.5 kgf-m, 18.1 ft-lb)
Slider bolt (B)
8 N·m (0.8 kgf-m, 5.8 ft-lb)
ME-02699
(A)
ME-00224
ME(H4SO)-36
ME-00225
(B)
(C)
(A)
ME-02699