Table of Contents
Advertisement
Immobilizer Control Module (ICM) Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove steering wheel referring to "Steering Wheel
Removal and Installation in Section 6B".
3) Remove steering column lower and upper covers.
4) Remove knee protector plate (1). (if equipped)
5) Remove engine start knob (2). (if equipped with
keyless start system)
1
6) Disconnect connector (1) from ICM (2).
7) Remove a screw (3) from ICM.
8) Remove ICM from steering lock assembly or
steering lock unit.
NOTE
The antenna part of ICM is fragile.
Therefore, do not add strong power to the
part or twist the part.
Installation
Reverse the removal procedure.
Repair Instructions
Registration of the Ignition Key
To finish the registration of the ignition key, the
S7RS0BA306001
transponder code memorized in the transponder built in
the ignition key has to be registered with ECM. To
register the transponder code with ECM, perform
"Register Ig Key" mode of SUZUKI scan tool referring to
"SUZUKI Tech 2 Operator's Manual".
2
Procedure after ECM Replacement
After ECM is replaced with new one or used one, the
transponder code in the transponder built in the ignition
key has to be registered with ECM. To register
I4RS0BA30006-03
transponder code in the ignition key with ECM, perform
"Replace New ECM" mode of SUZUKI scan tool
referring to "SUZUKI Tech 2 Operator's Manual".
2
3
1
I4RS0BA30007-03
Immobilizer Control System:
NOTE
• A maximum of four transponder codes can
be registered with ECM.
• At an early part of the registration process,
all transponder codes of the ignition keys
in use already registered with ECM are
cleared. Therefore, before starting the
registration, prepare all ignition keys in
use in addition to the new ignition key(s) to
be registered with ECM.
NOTE
A maximum of four transponder codes can
be registered with ECM.
10C-18
S7RS0BA306002
S7RS0BA306003
Hide quick links:
Advertisement
Chapters
Table of Contents
