Immobilizer Control Module (Icm) Removal And Installation; Registration Of The Ignition Key; Procedure After Ecm Replacement; Procedure After Immobilizer Control Module (Icm) Replacement - Suzuki Grand Vitara 2011 Manual

Immobilizer Control Module (ICM) Removal and
Installation
Removal
1) Disconnect negative (–) cable from battery.
2) Disable air bag system referring to "Disabling Air
Bag System in Section 8B".
3) Remove driver air bag (inflator) module referring to
"Driver Air Bag (Inflator) Module Removal and
Installation in Section 8B".
4) Remove steering wheel referring to "Steering Wheel
Removal and Installation in Section 6B".
5) Remove steering column lower and upper covers.
6) Disconnect connector (1) from ICM (2).
7) Remove a screw (3) from ICM.
8) Remove ICM from steering lock assembly.
NOTE
The antenna part of ICM is fragile. Therefore,
do not add strong power to the part or twist
the part.
Installation
Reverse the removal procedure noting the following.
• After ICM replaced, perform "Procedure after
Immobilizer Control Module (ICM) Replacement: For
Diesel Engine Model".
Immobilizer Control System: For Diesel Engine Model 10C-56
Repair Instructions

Registration of the Ignition Key

To finish the registration of the ignition key, the
S6JB0AA326001
transponder code memorized in the transponder built in
the ignition key has to be registered with ICM. To register
the transponder code with ICM, perform "Register Ig
Key" mode of SUZUKI scan tool referring to "SUZUKI
scan tool Operator's Manual".
2

Procedure after ECM Replacement

After ECM is replaced with new one or used one, the key
verification code stored in the ECM has to be registered
with immobilizer control system. To register key
3
verification code stored in the ECM with immobilizer
1
control system, perform "Replace ECM" mode of
SUZUKI scan tool referring to "SUZUKI scan tool
Operator's Manual".
I4RS0BA30007-03
Procedure after Immobilizer Control Module
(ICM) Replacement
After ICM replaced with new one or used one,
transponder code memorized in the transponder built in
the ignition key in use has to be registered with ICM and
then, key verification code stored in the ICM has to be
registered with immobilizer control system. To register
ignition key in use with ICM and to register verification
code stored in the ICM with immobilizer control system,
perform "Replace Immobilizer Module" mode of SUZUKI
scan tool referring to "SUZUKI scan tool Operator's
Manual".
NOTE
• A maximum of four transponder codes can
be registered with ICM.
• At an early part of the registration process,
all transponder codes of the ignition keys
in use already registered with ICM are
cleared. Therefore, before starting the
registration, prepare all ignition keys in
use in addition to the new ignition key(s) to
be registered with ICM.
NOTE
• A maximum of four transponder codes can
be registered with ICM.
• At an early part of the registration process,
all transponder codes of the ignition keys
in use already registered with ICM are
cleared. Therefore, before starting the
registration, prepare all ignition keys in
use in addition to the new ignition key(s) to
be registered with ICM.
S6JB0AA326002
S6JB0AA326003
S6JB0AA326004