Rear Wheel Alignment Inspection; Adjust Camber And Toe-In - Toyota Celica 2000 Repair Manual

SA-8
Fr o nt
--
-
-
- :
--
SUSPENSION AND AXLE
REAR WHEEL ALIGNMENT
INSPECTION
MEASURE VEHICLE HEIGHT (See page SA-4)
1 .
INSTALL CAMBER-CASTER-KINGPIN GAUGE OR
2.
TER
Follow the specific instructions of the equipment manufacturer.
INSPECT CAMBER
3.
Camber;
Camber
!f the camber is not within the specified value, after the toe-in
is inspected, see step 5. to adjust.
INSPECT TOE-IN
4.
Toe-in;
If the toe-in is not within the specified value, see step 5. to ad­
just

ADJUST CAMBER AND TOE-IN

5.
Measure the distance from the LH lower suspension arm
{a)
bracket set bolt to the RH axle carrier rear side set bolt as
shown in the illustration.
Employ the same manner to the RH�LH.
{b)
Length difference: 6 mm or less
If it exceeds the specified value, adjust it by turning the adjust­
ing cams.
Loosen the upper and lower arm adjusting cam set nuts.
{c)
Adjust the camber and toe-in by turning the adjusting
(d)
cams.
HINT:
Try to adjust the camber and toe-in to the center of the specified
values.
Torque the upper and lower arm adjusting cam set nuts.
{e)
-
Torque: 74 N-m (755 kgf.cm, 55 ff.Jbf)
-
--
- -
--
f1EAf-l WHEELAL!GNMENT
POSITION VEHICLE ON WHEEL ALIGNMENT TES·
H<ght--left error
A + f:l : 0 ' 1 8' ± 1 2' (0.3" ± 0.2")
Toe-i�
{total) C - 0- 3 + ? mm (0. 1 2 ± 0 08 i n )
-1 ' 1 1 ' ± 45' {--1.18° :!; 0.75')
less
45' (0. n n or