Rear Wheel Adjustment - Toyota Avensis ZZT251 2003 Service And Repair Manual

27–4
REAR WHEEL ALIGNMENT
ADJUSTMENT
1. INSPECT TIRE (See page
2. MEASURE VEHICLE HEIGHT
NOTICE:
Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
A
D
Front
C
4. INSPECT CAMBER
(a) Install the camber–caster–kingpin gauge or position the vehicle on the wheel alignment tester.
(b) Inspect the camber.
Camber:
(Normal package)
Camber
(Rough road package)
Camber
If the measured value is not within the specified value, inspect the suspension parts for damage and/or wear
and replace them if necessary because camber is not adjustable.
AVENSIS REPAIR MANUAL (RM1018E)
REAR SUSPENSION – REAR WHEEL ALIGNMENT
28–1)
(See page 26–6)
3. INSPECT TOE–IN
B
Toe–in:
(Normal package)
Toe–in
(total)
(Rough road package)
Toe–in
(total)
If the toe–in is not within the specified value, inspect the sus-
SA3213
pension parts and replace them if necessary.
Right–left error
Right–left error
5. ADJUST CAMBER AND TOE–IN
(a) Measure the distance from the LH rear suspension arm
bracket assy set bolt to the RH rear axle carrier rear side
set bolt as shown in the illustration.
(b) Measure the distance from the RH rear suspension arm
bracket assy set bolt to the LH rear axle carrier rear side
set bolt as shown in the illustration.
(c) Employ the same manner to the LH–RH.
Length difference: 6.0 mm (0.236 in.) or less
G23862
If the difference exceeds the specified value, adjust it by turning
the camber adjusting cam assy and tie rod adjusting tube.
http://vnx.su
A + B: 0 18' B 12' (0.3 B 0.2 )
C – D: 3.0 B 2.0 mm (0.12 B 0.08 in.)
A + B: 0 (C' B 12' (0.3 B 0.2 )
C – D: 3.0 B 2.0 mm (0.12 B 0.08 in.)
–0 FE' B 30' (–0.9 B 0.5 )
30' (0.5 ) or less
–0 )-' B 30' (–0.5 B 0.5 )
30' (0.5 ) or less
270E1–01