Table of Contents
Advertisement
Chapter 3: Basic Operations
This chapter describes the basic methods to operate the plotter manually.
All the operations described in this chapter is to start from the READY status (media is set) as a general
condition.
Perform the operation described in this chapter after making the plotter in READY status referring to
previous chapter.
PRODUCT SUMMARY
3.1
Raise or Lower the Tool
3.2
Move the Tool Carriage and Media
3.3
Setting the Origin Point
3.4
Setting the Cutting Direction
3.5
Stop Cutting
3-1
Advertisement
Table of Contents
Troubleshooting
