Combination Meter Digital Clock Set Procedure - Honda CRF1000 Shop Manual

dummyhead dummyhead
3. ECM/PCM inspection
Connect the 32P (Gray) connector.
Replace the ECM/PCM with a known good one
(page 22-12), and recheck.
Is the combination meter display normal?
YES
NO
COMBINATION METER DIGITAL
CLOCK SET PROCEDURE
1. Turn the ignition switch ON.
2. Press and hold the SET [1] and DOWN [2] buttons,
then the hour digits start blinking.
• The combination meter enters the clock setting
mode.
3. Press the UP [3] or DOWN button until the desired
hour is displayed.
• Press and hold the UP or DOWN button to advance
the hour fast.
4. Push the SET button [1], then the minute digits start
blinking.
5. Press the UP [1] or DOWN [2] button until the
desired minute is displayed.
• Press and hold the UP or DOWN button to advance
the minute fast.
6. Press the SET button [3], then the digital clock is set.
7. Turn the ignition switch OFF.
– Faulty original ECM/PCM
– Faulty combination meter
LIGHTS/METERS/SWITCHES
[3]
[1]
[2]
[1]
[1]
[2]
[3]
22-15