Honda CRF1000 Shop Manual page 433

dummyhead dummyhead
Install the fork spring [1] into the slide pipe assembly
with the tightly wound side facing down.
Install the spring collar [2] and spring seat stopper [3].
Clench the lock nut [1] until it is fully seated.
Attach the special tool to the spring collar holes [2].
TOOL:
Spring collar holder [3]
While pulling the damper rod holder [4] up, compress
the spring collar [5] with the special tool.
Insert the special tool between the lock nut and spring
seat stopper [6].
TOOL:
Stopper plate [7]
Remove the damper rod holder.
When installing the fork bolt assembly [1], turn the
rebound adjuster [2] counterclockwise to the softest
position.
Apply fork fluid to a new O-ring [3] and install it to the
fork bolt assembly.
Install the fork bolt assembly to the fork damper until it
is fully seated.
Tighten the fork bolt to the specified torque while
Be careful not to
holding the lock nut [1].
damage the fork
bolt when tightening
TORQUE: 20 N·m (2.0 kgf·m, 15 lbf·ft)
it.
Remove the stopper plate [2] and spring collar holder
[3].
FRONT WHEEL/SUSPENSION/STEERING
Down
[1]
070MF-MBZC110
[7]
[6]
070MF-MBZC130
[5]
[2]
[1]
[3]
[1]
[2]
[1]
[4]
[3]
[2]
[3]
[1]
[2]
[3]
17-21