Clutch Oil Feed Pipe Inspection; Clutch Oil Feed Pipe Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
INSPECTION
Inspect the following parts for scratches, bending or
clogging.
– Inner clutch oil feed pipe
– Outer clutch oil feed pipe
Measure each part according to DUAL CLUTCH
TRANSMISSION SPECIFICATIONS (page 1-8).
Replace any part if it is out of service limit.
INSTALLATION
Apply engine oil to a new O-ring [1] and install it to the
outer clutch oil feed pipe [2].
Install the outer clutch oil feed pipe into the right
crankcase cover by aligning the feed pipe bosses with
the right crankcase cover grooves.
Apply engine oil to new O-rings [1] and install them to
the feed pipe guide plate grooves.
Install the feed pipe guide plate [2] by aligning its pin
with the right crankcase cover hole.
Install and tighten the bolts [1] to the specified torque.
TORQUE: 5.0 N·m (0.5 kgf·m, 3.7 lbf·ft)
DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
[2] [1]
Align
[2] [1]
Align
[1]
13-51