Inner Mainshaft Sensor Removal/Installation; Outer Mainshaft Sensor Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
Install the drum shifter collar [1] onto the drum shifter.
Install the washer [2] onto the gearshift spindle [3] and
insert the spindle into the crankcase while aligning the
return spring ends with spring pin and the spindle arm
hole with the drum shifter collar.
Install the following:
– Dual clutch (page 13-69)
– Reduction gears/shift control motor (page 13-73)
MAINSHAFT SENSOR
INNER MAINSHAFT SENSOR
REMOVAL/INSTALLATION
Support the motorcycle using a safety stand or hoist,
raise the rear wheel off the ground.
Remove the rear shock absorber (page 18-8).
Release the inner mainshaft sensor 3P (Black)
connector [1] from the connector clip stay and
disconnect it.
Remove the bolts [2], inner mainshaft sensor [3], and
O-ring [4].
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Apply engine oil to a new O-ring.
OUTER MAINSHAFT SENSOR
REMOVAL/INSTALLATION
Remove the battery box (page 21-6).
Disconnect the outer mainshaft sensor 3P (Black)
connector [1].
Remove the bolt [2] and outer mainshaft sensor [3], and
O-ring [4].
Installation is in the reverse order of removal.
• The outer mainshaft sensor and VS sensor are the
same parts.
• Replace the O-ring with a new one.
• Apply engine oil to a new O-ring.
13-78
[2]
[3]
[1]
Align
[2]
[3] [4]
[3]
[4]
Align
[1]
[2]
[1]