Table of Contents
Advertisement
dummyhead
dummyhead
STARTER MOTOR
REMOVAL/INSTALLATION
Remove the battery box (page 21-6).
Remove the bolts [1] and starter motor [2].
Remove the O-ring [1].
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Apply engine oil to the new O-ring.
DISASSEMBLY/ASSEMBLY
The armature coil may be damaged if the magnet pulls the armature against the motor case.
SETTING BOLTS
4.9 N·m (0.5 kgf·m, 3.6 lbf·ft)
TERMINAL BOLT
SCREW/WASHER
3.7 N·m (0.4 kgf·m, 2.7 lbf·ft)
NEGATIVE BRUSH
SPRINGS
BRUSH HOLDER
O-RING
POSITIVE BRUSH
STOPPER
O-RING
REAR COVER
[2]
FRONT COVER
O-RINGS
SEAL RING
TERMINAL
STOPPER
INSULATOR
STARTER CABLE
WASHER
NUT/WASHER
ELECTRIC STARTER
[1]
MOTOR CASE
SEAL RING
ARMATURE
STARTER CABLE
TERMINAL NUT/WASHER
10 N·m (1.0 kgf·m, 7 lbf·ft)
[1]
6-5
Advertisement
Table of Contents
Troubleshooting
