Honda CRF1000 Shop Manual page 446

dummyhead dummyhead
REAR WHEEL/SUSPENSION
WHEEL BEARING REPLACEMENT
Drive out the rear wheel distance collar B [1] by using
the special tools.
TOOLS:
Driver [2]
Attachment, 22 x 24 mm [3]
Pilot, 17 mm [4]
Drive out the bearing [5].
Install the bearing remover head [1] into the bearing.
Replace the wheel
From the opposite side, install the bearing remover
bearings in pairs.
shaft [2] and drive out the bearing from the wheel hub.
Do not reuse old
bearings.
TOOLS:
Bearing remover head, 20 mm
Bearing remover shaft
Remove the distance collar and drive out the other
bearing.
Drive in a new right side bearing [1] squarely until it is
Never install the old
fully seated.
bearing, once the
bearing has been
TOOLS:
removed, the
Driver [2]
bearing must be
Attachment, 42 x 47 mm [3]
replaced with new
ones. Pilot, 20 mm [4]
Install the distance collar.
Drive in a new left side bearing squarely until it is
seated on the distance collar.
Drive in the rear wheel distance collar B [1] to a new
bearing [2].
TOOLS:
Driver [3]
Attachment, 28 x 30 mm [4]
Pilot, 20 mm [5]
18-6
07749-0010000
07746-0010800
07746-0040400
[3]
[4]
07746-0050600
07GGD-0010100
[1]
07749-0010000
07746-0010300
07746-0040500
07749-0010000
07946-1870100
07746-0040500
[1]
[1]
[2]
[2]
[5]
[1]
[2]
[2]
[3]
[4]
[3]
[4]
[5]