Headlight Removal/Installation; Headlight Troubleshooting - Honda CRF1000 Shop Manual

Hide thumbs Also See for CRF1000:
Table of Contents

Advertisement

dummyhead
dummyhead
LIGHTS/METERS/SWITCHES
HEADLIGHT
REMOVAL/INSTALLATION
Remove the front cover (page 2-7).
Disconnect the open air temperature sensor 2P (Black)
connector (page 22-17).
Remove the bolt/washers [1] and collars [2].
Release the front sub wire harness clip [3].
Disconnect the following:
– Bank angle sensor 2P (Black) connector [4]
– Headlight 2P connector [5]
– Headlight 2P (Black) connector [6]
Remove the headlight assembly [7].
Installation is in the reverse order of removal.
TROUBLESHOOTING
• Check the following before troubleshooting:
– Blown main fuse 30 A
– Blown sub fuse HEAD LIGHT LO 7.5 A
– Blown sub fuse HEAD LIGHT HI 7.5 A
– Blown sub fuse ILLUMI STOP 7.5 A
– Loose or poor contact on the headlight 2P,
headlight 2P (Black), and left handlebar switch
12P (Gray) (CRF1000)/10P (Gray) (CRF1000A/D)
connectors
• If any LED in the headlight [1] does not turn on,
replace the headlight unit (page 22-4).
• If the sub fuse is blown again, check for the short
circuit in the related wires.
– CRF1000 (page 24-2)
– CRF1000A (page 24-3)
– CRF1000D (page 24-4)
Headlight does not light at all with the ignition
switch turned ON
• Open circuit in the headlight ground line (Green
wire)
• Faulty headlight unit
Low beam headlight does not light with the ignition
switch turned ON
• Open circuit in the White/black wire between the
fuse box 1 and headlight unit
• Faulty headlight unit
22-4
[4]
[7]
[3]
[5]
[6]
[2]
[1]
[1]

Advertisement

Table of Contents
loading

This manual is also suitable for:

Crf1000aCrf1000d

Table of Contents