Fork Installation; Steering Stem Removal - Honda CRF1000 Shop Manual

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
Install the fork bolt [1].
Tighten the fork bolt
after installing the
fork slider into the
steering stem.
INSTALLATION
Install the forks through the bottom bridge and top
bridge so that the end of the outer pipe [1] is aligned
with the top bridge [2] upper surface.
Tighten the bottom bridge pinch bolts [3] to the
specified torque.
TORQUE: 25 N·m (2.5 kgf·m, 18 lbf·ft)
If the fork bolt [4] is loosened, tighten it to the specified
Be careful not to
torque.
damage the fork
bolt when tightening
TORQUE: 35 N·m (3.6 kgf·m, 26 lbf·ft)
it.
Tighten the top bridge pinch bolts [5] to the specified
torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Return the pre-load and rebound damping adjusters to
the original positions as noted during disassembly.
– Front speed sensor (CRF1000A/D) (page 20-20)
– Front wheel (page 17-14)
– Front fender (page 2-9)
STEERING STEM
REMOVAL
Remove the air cleaner case (page 7-11).
Remove the handlebar lower holder (page 17-7).
Disconnect the immobilizer receiver 4P (Black) [1] and
ignition switch 2P (Brown) [2] connectors.
17-22
[1]
[2] [4] [5]
[1]
[2]
[3]
[1]