Brake Pad/Disc; Front Brake Pad Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
HYDRAULIC BRAKE
Install the diaphragm [1], set plate [2], and reservoir cap
Front brake:
[3] and tighten the screws [4] to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Remove the mounting bolt [1] and rear brake reserve
Rear brake:
tank [2].
Install the diaphragm [3], set plate [4], reservoir cap [5],
and screws [6] and tighten the screws to the specified
torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Install the rear brake reserve tank and mounting bolt
and tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)

BRAKE PAD/DISC

• Always replace the brake pads in pairs to assure
even disc pressure.
• Check the brake fluid level in the brake master
cylinder reservoir as this operation causes the level
to rise.
FRONT BRAKE PAD REMOVAL/
INSTALLATION
Remove the brake caliper mounting bolts [1] and brake
Do not operate the
calipers [2].
brake lever after
removing the brake
caliper.
19-8
[4]
[3]
[2]
[1]
[6]
[5]
[4]
[3]
[2]
[1]
Right side shown:
[2]
[1]