Gearshift Linkage - Removal - Honda CRF1000 Shop Manual

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
Coat a new O-ring [1] with engine oil and install it into
the groove in the shift control motor [2].
Install the shift control motor onto the shift control motor
cover.
Install the torx bolts [1] and tighten it to the specified
torque.
TORQUE: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Connect the shift control motor 2P (Black) connector
[2].
Install the shift control motor cover [1] and bolts [2] and
tighten the bolts to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
• Route the wire properly (page 1-26)
GEARSHIFT LINKAGE
REMOVAL
Remove the following:
– Shift control motor/reduction gears (page 13-71)
– Dual clutch (page 13-63)
– Gearshift spindle [1]
– Washer [2]
– Drum shifter collar [3]
13-74
[1]
[2]
[1]
[2]
[2]
[1]
[3]
[2]
[1]