Front Wheel Removal - Honda CRF1000 Shop Manual

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
Install the front brake master cylinder [1] by aligning its
end with the paint mark [2] on the handlebar.
Install the holder [3] with its "UP" mark [4] facing up.
Tighten the upper bolt [5] first, then the lower bolt [6] to
the specified torque.
TORQUE: 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
Install the wire clamp [1] and connect the front brake
light switch connectors [2].
Install the knuckle guards (page 2-5).
Install the rearview mirrors [1].
FRONT WHEEL
REMOVAL
Remove the front brake caliper mounting bolts [1] and
slide the brake caliper/bracket assembly [2].
• Do not suspend the brake caliper/bracket assembly
from the brake hose. Do not twist the brake hose.
• Do not operate the brake lever after removing the
front wheel.
17-10
[1]
[5]
[4]
[6] [1] [3]
[1]
[1]
Left side shown:
[2]
[2]
[2]
[1]