Honda CRF1000 Shop Manual page 311

dummyhead dummyhead
4. Outer Mainshaft Sensor Ground Line Open
Circuit Inspection
Disconnect the PCM 33P (Black) connector (page
4-39).
Check for continuity between the wire harness side
3P (Black) connector [1] and 33P (Black) connector
[2]
TOOL:
Test probe
Connection: Gray – B13
Is there continuity?
YES
NO
5. Outer Mainshaft Sensor Output Line Inspection
Measure the voltage between the wire harness side
3P (Black) connector [1] and ground.
Connection: Pink (+) – Ground (–)
Is the voltage within 4.75 – 5.25 V?
YES
NO
6. Outer Mainshaft Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Blue) connector (page 4-
39).
Check for continuity between the wire harness side
3P (Black) connector [1] and 33P (Blue) connector
[2].
TOOL:
Test probe
Connection: Pink – A25
Is there continuity?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
07ZAJ-RDJA110
– Replace the PCM with a known good one
(page 4-39) and recheck.
– Open circuit in the Gray wire
– GO TO STEP 8.
– GO TO STEP 6.
07ZAJ-RDJA110
– GO TO STEP 7.
– Open circuit in the Pink wire
[1] [2]
Gr
[1]
P
[1] [2]
P
B13
A25
13-41