Side Cover Disassembly/Assembly; Rear Carrier Removal/Installation; Rear Fender A Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM
DISASSEMBLY/ASSEMBLY
Remove the side cover (page 2-11).
Remove the screws [1].
Remove the side inner cover [2] by releasing the tab [3].
Installation is in the reverse order of removal.
REAR CARRIER
REMOVAL/INSTALLATION
Remove the side covers (page 2-11).
Remove the socket bolts [1].
Remove the flange bolts A [2].
Remove the flange bolts B [3] and collars [4].
Remove the flange bolts C [5] and washers [6].
Remove the rear carrier [7].
Installation is in the reverse order of removal.
REAR FENDER A
REMOVAL/INSTALLATION
Remove the rear carrier (page 2-12).
Disconnect the following connectors.
– Right rear turn signal light 2P (Light blue) connector
[1]
– Left rear turn signal light 2P (Orange) connector [2]
– License light 3P (White) connector [3]
Remove the socket bolts A [4], socket bolts B [5], and
collars [6].
Remove the rear fender A [7] while pulling rearward by
releasing its tabs [8] from the rear fender B.
Installation is in the reverse order of removal.
• Route the wires properly (page 1-26).
2-12
[1]
[1]
[3]
[6] [5] [4] [3]
[2]
[5]
[6]
[7]
[8]
[7]
[4]
[5] [6]
[2]
[3] [1]
[2]
[1]