Cushion Assembly/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
CUSHION CONNECTING ROD
Remove the needle bearings (17 x 24 x 30 mm) [1].
TOOLS:
Bearing remover set, 17 mm [2] 07936-3710300
Remover weight [3]
Remover handle [4]
Apply molybdenum disulfide grease to new needle
Never install the old
bearings rotating area.
bearing, once the
bearing has been
Install the needle bearings (17 x 24 x 30 mm) [1] with its
removed, the
marked side facing up until it is flush with the cushion
bearing must be
arm surface using the special tools and hydraulic press
replaced with a new
as shown.
one.
TOOLS:
Driver [2]
Attachment, 32 x 35 mm [3]
Pilot, 17 mm [4]
ASSEMBLY/INSTALLATION
Install the dust seals [1] into the cushion arm [2] until
they are fully seated.
Apply molybdenum disulfide grease to dust seal lips.
Install the collars [3].
Install the collar [1] into the cushion connecting rod [2].
[4]
07741-0010201
07936-3710100
[2]
07949-0010000
07746-0010100
07746-0040400
[3]
REAR WHEEL/SUSPENSION
[3]
[1]
[1]
[2]
[2] [1]
[3]/[4]
[1]
[2]
[1]
18-11