Honda CRF1000 Shop Manual page 373

dummyhead dummyhead
SHIFT CONTROL MOTOR REDUCTION GEAR
BEARING (CRF1000D)
Heat the upper crankcase to 80°C (176°F) evenly using
Do not use a torch
a heat gun.
to heat the upper
crankcase; it may
Tap the upper crankcase lightly and remove the
cause warping.
bearings.
– Radial ball bearing (607ZZ) [1]
– Radial ball bearing (696ZZ) [2]
Apply engine oil to new bearings.
Drive in the bearings squarely with the marking side
facing up until they are fully seated.
Install the removed parts in the reverse order of
removal.
GEARSHIFT SPINDLE NEEDLE BEARING
(CRF1000D)
Heat the upper crankcase to 80°C (176°F) evenly using
Do not use a torch
a heat gun.
to heat the upper
crankcase; it may
Tap the upper crankcase lightly and remove the
cause warping.
gearshift spindle needle bearing [1].
Apply engine oil to a new needle bearing.
Drive in the needle bearing with the marking side facing
toward the outside of the crankcase until it is in position
as shown.
TOOLS:
Seal driver, 14 x 22 mm
Install the removed parts in the reverse order of
removal.
CRANKCASE/TRANSMISSION/BALANCER
07PPD-YE10100
17.7 – 18.2 mm
(0.70 – 0.72 in)
[1]
[2]
[1]
[1]
14-19