Starter Clutch Inspection; Starter Clutch Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
ALTERNATOR/STARTER CLUTCH
Hold the flywheel [1] using the special tool and remove
the starter clutch torx bolt [2].
TOOL:
Flywheel holder [3]
Remove the starter clutch assembly [1].
Remove the starter one-way clutch [2] from the starter
clutch outer [3].
INSPECTION
Inspect the following parts for scratch, damage,
abnormal wear, or deformation.
– Starter driven gear
– Starter clutch outer
– Starter one-way clutch
Measure each part according to ALTERNATOR/
STARTER CLUTCH SPECIFICATIONS (page 1-8).
Replace any part if it is out of service limit.
INSTALLATION
Apply engine oil to the starter one-way clutch sliding
surface.
Install the starter one-way clutch [1] to the starter clutch
outer [2].
Install the starter clutch assembly [3].
11-10
07725-0040001
[1]
[2]
[2]
[3]
[2]
[3]
[1] [3]
[1]