Honda CRF1000 Shop Manual page 361

dummyhead dummyhead
FRONT BALANCER DRIVEN GEAR DISASSEMBLY
Remove the front balancer driven gear (page 14-6).
Set the special tools onto the front balancer driven gear
To prevent loss of
[1] as shown and remove the snap ring [2] by
spring tension, do
compressing the return spring assembly.
not compress the
spring assembly
TOOL:
more than
Clutch compressor set [3]
necessary.
Remove the special tools.
Disassemble the following:
– Washer [1]
– Friction spring [2]
– Front balancer sub driven gear [3]
– Springs [4]
– Front balancer driven gear [5]
INSPECTION
Inspect the following parts for scratch, damage,
abnormal wear, or deformation.
– Balancer driven gear
– Balancer driven sub-gear
– Springs
– Balancer shaft
– Balancer shaft bearings
Replace if necessary.
FRONT BALANCER DRIVEN GEAR ASSEMBLY
Assemble the following:
– Front balancer driven gear [1]
– Springs [2]
– Front balancer sub driven gear [3]
– Friction spring [4]
– Washer [5]
• Apply molybdenum oil solution to the balancer
driven gear, sub driven gear, friction spring, and
washer sliding surface.
• Install the sub driven gear by aligning its boss as
shown.
• Install the friction spring as shown.
CRANKCASE/TRANSMISSION/BALANCER
07LAE-PX40000
[1]
[1]
[5]
[5]
[2]
[4] [5]
[3]
[2]
[4]
[4]
[3]
[3] [2] [1]
14-7