Honda CRF1000 Shop Manual page 305

dummyhead dummyhead
3. TR Sensor Input Line Open Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector (page
4-39).
Check for continuity between the wire harness side
3P (Black) connector [1] and 33P (Black) connector
[2].
TOOL:
Test probe
Connection: Yellow/red – B27
Is there continuity?
YES
NO
4. TR Sensor Ground Line Open Circuit Inspection
Check for continuity between the wire harness side
33P (Black) connector [1] and 3P (Black) connector
[2].
TOOL:
Test probe
Connection: Gray/black – B13
Is there continuity?
YES
NO
5. TR Sensor Signal Line Open Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Blue) connector (page 4-
39).
Check for continuity between the wire harness side
3P (Black) connector [1] and 33P (Blue) connector
[2].
TOOL:
Test probe
Connection: White – A18
Is there continuity?
YES
NO
6. TR Sensor Output Line Short Circuit Inspection
Check for continuity between the wire harness side
3P (Black) connector [1] and ground.
Connection: White – Ground
Is there continuity?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
07ZAJ-RDJA110
– GO TO STEP 4.
– Open circuit in the Yellow/red wire
07ZAJ-RDJA110
– Replace the PCM with a known good one
(page 4-39) and recheck.
– Open circuit in the Gray/black wire
07ZAJ-RDJA110
– GO TO STEP 6.
– Open circuit in the White wire
– Short circuit in the White wire
– GO TO STEP 7.
[1] [2]
Y/R
[1] [2]
Gr/Bl
[1] [2]
W A18
[1]
W
B27
B13
13-35