Honda CRF1000 Shop Manual page 262

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE (CRF1000/A)
Stake the clutch center lock nut [1] into the mainshaft
Be careful not to
groove.
damage the
mainshaft threads.
Apply molybdenum oil solution to the entire surface of
judder spring seat and judder spring.
Install the judder spring seat [1] and judder spring [2]
onto the clutch center [3] as shown.
Apply engine oil to the entire surface of clutch discs.
Install the clutch disc A [4] and plate B [5] onto the
clutch center.
• Clutch disc A: smaller lining width than disc B
• Clutch plate B: surface treatment difference from
clutch plate A
Install the clutch discs C [6] (5 pcs) and plates A [7] (5
pcs) alternately, starting with the disc C.
Install the clutch disc A [8].
Install the clutch lifter pin [1].
Install the spring seats [2] onto the clutch pressure plate
[3] grooves.
• Make sure that the spring seats are fully seated in
the pressure plate grooves.
Apply engine oil to the entire surface of clutch disc B.
Install the clutch disc B [4] onto the clutch pressure
plate.
Install the clutch plate C [5] by aligning its tabs with the
pressure plate grooves.
Put the clutch pressure plate assembly onto the clutch
center [6] by aligning each cam area and insert them by
rotating counterclockwise.
Install the clutch disc B tabs into the shallow slots of the
clutch outer [7] as shown.
12-14
Stake
[1]
[1]
[2]
[1]
[2]
[8]
[2]
[4]
[3]
[5]
[3]
[4] [7]
[3]
[4]
[5]
[7] [6]
[1]
[6]
[7]
[4]
[7]