Combination Meter - Honda SH300 2006 Manual

LIGHTS/METERS/SWITCHES

COMBINATION METER

BULB REPLACEMENT
Remove the front handlebar cover (page 3-14).
Remove the rubber cap.
Remove the bulb by turning it counterclockwise and
replace it with a new one.
Installation is in the reverse order of removal.
METER INSPECTION
INITIAL FUNCTION
When the ignition switch turns ON, check that the
speedometer, fuel gauge and coolant temperature
gauge needles move to full scale and then return to
zero.
If the all needles does not move, perform the power
and ground line inspection of the combination
meter (page 22-8).
POWER/GROUND LINE INSPECTION
POWER INPUT LINE
Remove the front handlebar cover (page 3-14).
Disconnect the combination meter 16P connector.
Measure the voltage between the Black/Brown wire
terminal (+) of the 16P connector of the wire harness
side and ground (–).
There should be battery voltage with the ignition
switch turned "ON".
If there is no voltage, check for open circuit in Black/
Brown wire.
22-8
CAP
16P CONNECTOR
(Wire side of female
terminal)
METER 16P
CONNECTOR
BULB
Bl/Br