Eop Sensor Removal/Installation (Crf1000D) - Honda CRF1000 Shop Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
Release the rubber cap [1].
Remove the bolt/washer [2] and disconnect the EOP
switch terminal [3].
Remove the EOP switch [4].
Installation is in the reverse order of removal.
• Apply sealant to the EOP switch threads as shown.
• Route the wire properly (page 1-26).
TORQUE:
EOP switch:
12 N·m (1.2 kgf·m, 9 lbf·ft)
EOP switch terminal bolt/washer:
2.0 N·m (0.2 kgf·m, 1.5 lbf·ft)
Fill the engine oil with the recommended engine oil
(page 3-12).
EOP SENSOR REMOVAL/
INSTALLATION (CRF1000D)
Drain the engine oil (page 3-12).
Remove the bolts [1] and alternator assembly wire
cover [2].
Drain the engine oil (page 3-12).
Disconnect the EOP sensor 3P (Black) connector [1].
Remove the EOP sensor [2].
22-20
[4]
3 – 4 mm (0.1 – 0.2)
[2]
[1]
[2]/[3]
[1]
[4]
[1]
[2]