Honda CRF1000 Shop Manual page 456

dummyhead dummyhead
REAR WHEEL/SUSPENSION
Remove the needle bearing [1] out of the left pivot using
a hydraulic press and special tool.
TOOLS:
Driver [2]
Attachment, 32 x 35 mm [3]
Pilot, 25 mm [4]
Apply molybdenum disulfide grease to a new needle
bearing rotating area.
Install the needle bearing [1] into the left pivot with the
marked side facing up to the specified range using a
hydraulic press and special tools as shown.
TOOLS:
Driver [2]
Attachment, 32 x 35 mm [3]
Pilot, 25 mm [4]
Apply molybdenum disulfide grease to a new needle
bearing (24 x 31 x 28 mm) rotating area.
Install the needle bearing (24 x 31 x 28 mm) [1] into the
right pivot with the marked side facing up to the
specified range using a hydraulic press and special
tools as shown.
TOOLS:
Driver, 15 x 280L [2]
Attachment, 28 x 30 mm [3]
Pilot, 22 mm [4]
Apply molybdenum disulfide grease to a new ball
bearing rotating area.
Install the ball bearing 6003 [1] into the right pivot with
the marked side facing out until it is fully seated using a
hydraulic press and special tools as shown.
TOOLS:
Driver [2]
Attachment, 32 x 35 mm [3]
Pilot, 17 mm [4]
18-16
07749-0010000
07746-0010100
07746-0040600
[2]
[1]
07749-0010000
07746-0010100
07746-0040600
[2]
07949-3710001
07946-1870100
07746-0041000
[1]
07749-0010000
07746-0010100
07746-0040400
[2]
[3]/[4]
[1]
[3]
5.0 – 5.5 mm
(0.20 – 0.22 in)
[1]
[4]
[3]
4.5 – 5.0 mm
(0.18 – 0.20 in)
[1]
[4]
[2]
[3]
[4]
[1]