Honda CRF1000 Shop Manual page 392

dummyhead dummyhead
CRANKSHAFT/PISTON/CYLINDER
Apply engine oil to the crankpin bearing cap bolt (reuse)
threads and seating surfaces.
Install and tighten the crankpin bearing cap bolts [1] to
the specified torque in 2 or 3 steps alternately.
Further tighten the bolts 90°.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft) + 90°
Remove
compressed plastigauge at its widest point on the
crankpin to determine the oil clearance.
SERVICE LIMIT: 0.065 mm (0.0026 in)
If the oil clearance exceeds the service limit, select the
correct replacement bearings.
BEARING SELECTION
Record the connecting rod I.D. code number [1] or
Numbers (1, 2, 3 or
measure the I.D. with the crankpin bearing cap installed
4) on the
without bearing inserts.
connecting rods are
the connecting rod
I.D. codes.
If you are replacing the crankshaft, record the
Letters (A, B, C or
corresponding crankpin O.D. code letter [1].
D) on the crank
weight are the
If you are reusing the crankshaft, measure the crankpin
crankpin O.D.
O.D. with a micrometer.
codes from left to
right.
15-10
the bearing caps and
[1]
measure the
[1]
[1]