Honda CRF1000 Shop Manual page 533

dummyhead dummyhead
POWER INPUT LINE
Measure the voltage at the wire harness side 32P
(Gray) connector [1] and ground.
CONNECTION: Black/red (+) – Ground (–)
STANDARD:
There should be battery voltage with the ignition switch
turned ON.
If there is no voltage, check the following:
– Open circuit in the Black/red wire
– Blown sub fuse ILLUMI STOP 7.5 A
BACK-UP VOLTAGE LINE
Measure the voltage at the wire harness side 32P
(Gray) connector [1] and ground.
CONNECTION: Red/white (+) – Ground (–)
STANDARD:
There should be battery voltage at all times.
If there is no voltage, check the following:
– Open circuit in the Red/white wire
– Blown sub fuse CLOCK TURN 7.5 A
GROUND LINE
Check for continuity at the wire harness side 32P (Gray)
connector [1] and ground.
CONNECTION: Green – Ground
There should be continuity.
If there is no continuity, check for open circuit in the
Green wire.
Battery voltage
Battery voltage
LIGHTS/METERS/SWITCHES
[1]
Bl/R
[1]
R/W
[1]
G
22-13