Turn Signal Relay Removal/Installation/Inspection - Honda CRF1000 Shop Manual

dummyhead dummyhead
REAR
Remove the rear carrier (page 2-12).
Disconnect the rear turn signal light 2P connector.
– Right side: light blue [1]
– Left side: orange [2]
Remove the following:
– Nut [3]
– Collar [4]
– Grommet [5]
– Front turn signal light [6]
Installation is in the reverse order of removal.
TURN SIGNAL RELAY REMOVAL/
INSTALLATION
Remove the ABS modulator (page 20-24).
Remove the turn signal relay [1].
Installation is in the reverse order of removal.
INSPECTION
TURN SIGNAL LIGHT INSPECTION
• Check the following before inspection:
– Blown main fuse 30 A
– Blown sub fuse ILLUMI STOP 7.5 A
– Blown sub fuse CLOCK TURN 7.5 A
– Loose or poor contact on the turn signal light relay
18P (Black), right handlebar switch 8P (Gray), and
left handlebar switch 10P (Gray) connector
– Handlebar switch operation
• If the sub fuse is blown again, check for the short
circuit in the related wires.
– CRF1000A (page 24-3)
– CRF1000D (page 24-4)
Turn the ignition switch ON and operate the turn signal
switch.
Check each turn signal light operation.
Any LED does not blink.
Replace the turn signal light as an assembly.
LIGHTS/METERS/SWITCHES
Right side
shown:
[6]
[2]
[1]
[4]
[1]
[5]
[3]
22-9