Honda CRF1000 Shop Manual page 431

dummyhead dummyhead
Apply fork fluid to new dust seal and oil seal lips.
Install the dust seal [1], stopper ring [2] and oil seal [3].
Install the oil seal
with its marked side
Install the back-up ring [4], guide bushing [5].
facing toward the
Install the slider bushing [6] if it is removed.
axle holder.
• Remove any burrs from the bushing mating surface,
being careful not to peel off the coating.
• Do not open the slider bushing slit more than
necessary.
Install the slide pipe assembly [7] into the outer pipe [8].
Put the guide bushing [1], back-up ring [2] and oil seal
[3] on the outer pipe.
Put the special tool on the oil seal.
TOOL:
Fork seal driver, 45.2 mm [4]
Drive the oil seal with the guide bushing and back-up
See illustration for
ring into the outer pipe until the stopper ring groove [5]
correct seating.
is visible using the special tools.
Install the stopper ring [1] into the groove securely.
Do not scratch the
fork pipe sliding
Install the dust seal [2].
surface.
Install the fork damper assembly [1] and centering plate
[2].
FRONT WHEEL/SUSPENSION/STEERING
[1]
07KMD-KZ30100
[1]
[2] [3] [6]
[4] [5] [7]
[5]
[3]
[2]
[1]
[2]
[8]
[4]
[2]
[1]
17-19