Honda CRF1000 Shop Manual page 365

dummyhead dummyhead
INSPECTION
Inspect the following parts for scratch, damage,
abnormal wear, or deformation.
– Balancer driven gear
– Balancer sub driven gear
– Springs
– Balancer shaft
– Bearings
Replace if necessary.
REAR BALANCER DRIVEN GEAR ASSEMBLY
Assemble the following:
– Rear balancer driven gear [1]
– Springs [2]
– Rear balancer sub driven gear [3]
– Friction spring [4]
– Washer [5]
• Apply molybdenum oil solution to the balancer
driven gear, sub driven gear, friction spring, and
washer sliding surface.
• Install the sub driven gear by aligning its boss as
shown.
• Install the friction spring as shown.
Place the snap ring [1] onto the rear balancer driven
gear assembly [2].
Set the special tools onto the front balancer driven gear
To prevent loss of
assembly as shown and install the snap ring into the its
spring tension, do
guide groove by compressing the friction spring.
not compress the
spring assembly
TOOL:
more than
Clutch compressor set [3]
necessary.
• Install the snap ring with the chamfered edge facing
opposite side of the washer and make sure that it is
firmly seated in the groove.
Remove the special tools.
ASSEMBLY/INSTALLATION
Apply molybdenum oil solution to the oil pump driven
gear shaft outer surface.
Install the oil pump driven gear [1].
Apply locking agent to the bolt threads (page 1-20)
Install the set plate [2], washer [3], and bolt [4] and
tighten the bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
CRANKCASE/TRANSMISSION/BALANCER
07LAE-PX40000
[2]
[3]/[4]
[2]
[5] [4]
[5] [4] [3]
[1]
[1]
[2]
[3]
[1]
14-11