Rear Brake Pad Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
Remove the brake pads [1].
Check the pad spring [2] and replace if necessary.
Install new brake pads to the brake caliper so their ends
Align the pad lugs
seat against the pad spring.
with the caliper
grooves.
Install the brake caliper [1] and new mounting bolts [2].
Tighten the bolts to the specified torque.
TORQUE: 45 N·m (46 kgf·m, 33 lbf·ft)
Operate the brake lever to seat the caliper pistons
against the pads.
REAR BRAKE PAD REMOVAL/
INSTALLATION
Remove the brake pad pin [1] and rear brake caliper
mounting bolt [2].
Lift the caliper and remove the brake pads [3].
Do not operate the
brake pedal after
removing the brake
pads.
HYDRAULIC BRAKE
Right side shown:
Right side shown:
[1]
[3]
[2]
[1]
[2]
[1]
[2]
19-9