Rear Master Cylinder Removal/Installation - Honda CRF1000 Shop Manual

dummyhead dummyhead
HYDRAULIC BRAKE
REAR MASTER CYLINDER
REMOVAL/INSTALLATION
Drain the rear brake line hydraulic system (page 19-6).
Remove the bolt [1] and heel guard [2].
Remove the oil bolt [1], sealing washers [2] and brake
Avoid spilling fluid
hose [3].
on painted, plastic,
or rubber parts.
Remove the hose clamp [4] and rear master cylinder
hose [5].
Remove the cotter pin [1] and joint pin [2], and
disconnect the brake rod joint [3] from the middle arm
[4].
Remove the bolts [5] and rear master cylinder [6].
Installation is in the reverse order of removal.
• Always replace the cotter pin and sealing washers
with a new one.
• Tighten rear master cylinder mounting bolts and
brake hose oil bolt to the specified torque.
TORQUE:
Rear master cylinder mounting bolt:
14 N·m (1.4 kgf·m, 10 lbf·ft)
Brake hose oil bolt:
34 N·m (3.5 kgf·m, 25 lbf·ft)
19-16
[1]
[1]
[5]
[4]
[6]
[3]
[1]
[2]
[2]
[3]
[2]
[5]
[4]