Table of Contents
Advertisement
dummyhead
dummyhead
FUEL SYSTEM
DISASSEMBLY/ASSEMBLY
• Do not remove the sensor unit unless it is replaced.
• Do not loosen or tighten the white painted nuts and
screws [1] and nuts [2] of the throttle body.
Loosening or tightening it can cause throttle valve
and idle control failure.
• Always clean around the throttle body before each
sensor removal to prevent dirt and debris from
entering the air passage.
• MAP sensor removal/installation (page 4-41)
• IACV removal/installation (page 7-16)
• Fuel injector removal/installation (page 7-17)
• If the O-ring is not installed properly, the idle air will
leak and engine idle speed will be unstable.
IACV HOLDER
IACV HOLDER SCREWS
3.4 N·m (0.3 kgf·m, 2.5 lbf·ft)
INSTALLATION
Connect the TP sensor 3P (Black) connector [1].
7-14
THROTTLE BODY
O-RING
[1]
THROTTLE BODY
SETTING PLATE
THROTTLE BODY SETTING
PLATE SCREWS
SET PLATE SEAL
[1]
[2]
Advertisement
Table of Contents
Troubleshooting
