Alternator Cover Removal/Installation (Crf1000D) - Honda CRF1000 Shop Manual

dummyhead dummyhead
Remove the dowel pins [1] and oil joint [2].
• Install the oil joint with the narrow hole side facing
out.
Clean off any sealant from the alternator cover mating
surfaces.
Installation is in the reverse order of removal.
• Apply liquid sealant (TB1207B manufactured by
Three bond or equivalent) to the alternator cover
mating surface as shown.
• Do not apply more liquid sealant than necessary.
• Route the wires properly (page 1-26).
TORQUE:
Alternator cover bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
REMOVAL/INSTALLATION
(CRF1000D)
Drain the engine oil (page 3-12).
Disconnect the EOP sensor 3P (Black) connector (page
22-20)
Remove the following:
– Left rear cover (page 2-10)
– Shift control motor cover (page 13-71)
– Connector cover (page 5-8)
Disconnect
connector [1].
Disconnect the alternator 3P (Gray) connector [1].
Release the alternator assembly wire [2] from the wire
clamp [3].
Release the wire clip [4].
Release the alternator assembly wire from the frame.
the alternator assembly
ALTERNATOR/STARTER CLUTCH
[1]
[1]
6P (Black)
[4]
[2]
[1]
[2]
[4] [3]
[2]
[1]
[2]
11-5