Headlight Relay Removal/Installation/Inspection; Turn Signal Light/Relay/Diode (Crf1000) Bulb Replacement - Honda CRF1000 Shop Manual

dummyhead dummyhead
High beam headlight does not light with the dimmer
switch pushed to "
• Open circuit in the Yellow/red wire between the fuse
box 1 and left handlebar switch
• Faulty dimmer switch (page 22-23)
• Faulty passing switch (page 22-23)
• Open circuit in the Blue/red wire between the left
handlebar switch and headlight relay
• Open circuit in the headlight relay power line (Blue/
red wire)
• Faulty headlight relay (page 22-5)
• Open circuit in the Blue wire between the headlight
relay and headlight unit
• Faulty headlight unit
HEADLIGHT RELAY
REMOVAL/INSTALLATION
Remove the right side cover (page 2-11).
Release the relay connectors from the frame and
remove the relay cover [1].
Remove the headlight relay [2].
Installation is in the reverse order of removal.
RELAY INSPECTION
Remove the headlight relay (page 22-5).
Refer to FI relay inspection (page 4-44).
TURN SIGNAL LIGHT/RELAY/DIODE
(CRF1000)
BULB REPLACEMENT
Remove the screw [1], turn signal lens [2], and seal
rubber [3].
While pushing in, turn the bulb [4] counterclockwise to
remove it and replace with a new one.
Install the seal rubber, lens and tighten the screw
securely.
" or passing switch pushed
LIGHTS/METERS/SWITCHES
[1]
[1]
[4]
[2]
[3]
[2]
22-5