Table of Contents
Advertisement
dummyhead
dummyhead
Check for continuity between the rear brake light switch
2P (Gray) connector [1] terminals.
There should be continuity with the brake pedal applied,
and there should be no continuity with the brake pedal
released.
CLUTCH SWITCH (CRF1000/A)
Disconnect the clutch switch connectors and check for
continuity between the terminals [1].
There should be continuity with the clutch lever applied,
and there should be no continuity with the clutch lever
released.
GEAR POSITION SWITCH (CRF1000/A)
REMOVAL/INSTALLATION
Remove the left rear cover (page 2-10).
Remove the rear shock absorber (page 18-8).
Disconnect the gear position switch 8P (Black)
connector [1].
Shift the transmission into neutral.
Remove the bolt [1], the gear position switch [2], and O-
ring [3].
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Apply engine oil to a new O-ring.
• When installing the gear position switch, shift the
transmission into neutral.
• Align the switch pin with the shift drum slot, being
careful not to damage the switch pin.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
LIGHTS/METERS/SWITCHES
[1]
CRF1000 shown:
[1]
Align
[2]
[1]
[1]
[3]
22-25
Advertisement
Table of Contents
Troubleshooting
